All prices are in All prices are in USD
BLU VIVO XL SUB PCBA WITH CHARGING PORT
MODEL V0030UU
Showing reviews 1-10 of 13 | Next
Posted by Unknown on 28th Jan 2018
Ordered on a late Friday afternoon had by Wednesday morning installed and no issues with shipping quality or price.
Posted by Steve on 20th Dec 2017
Part came fast and with a little soldering on the board phone charges great. Will use them again for other repairs I need to do
Posted by John on 30th Oct 2017
It took me an hour to install the circuit board. You must have the right tools. A soldering iron with a sharp tip is a must. The old circuit board is glued down. It was easy to break it away with a guitar pick. Removing the bezel was the hardest part not knowing how hard to pry it loose. When finished the phone worked great.
Posted by Paul on 12th Oct 2017
Fixes a common problem with the Blu Vivo XL -- namely that the charging port becomes defective / unusable over time through wear. As mentioned, is slightly tricky to solder the existing speaker to the new board, but other than that the entire procedure takes about 30 minutes to fix (assuming you have some experience and correct tools).
Posted by Ron on 27th Aug 2017
Swapped the small internal PCB with this replacement -- only needing to desolder/solder the speaker to the new board. That is the only challenging part, especially if you have little experience soldering: the solder pads for the wires are small. Replacement PCB works perfectly -- phone is back to normal.
Posted by Unknown on 8th Aug 2017
Correct part, good price, decent turnaround time on shipping and fairly easy installation. My phone had a problem charging and this part appears to have fixed it.
Posted by Rebecca on 6th Aug 2017
The part has fixed my phone, although with out knowing how to solder you cant fix this issue. Luckily for me my fiance was able to install the part. Also the part took a little long to ship, but all in all it was a decent experience and I would order from BluPhoneParts again.
Posted by Unknown on 2nd Aug 2017
Part was relatively easy to install, being careful and patient. It only needs a couple of soldering points to remove the round speaker from old chip and install it in the new one. Working fine so far. My problem was with the USB charging port that kept disconnecting when charging, apparently a common issue with the blu vivo xl. Hope this one will last longer than the original, which lasted less than a year.
Posted by Al on 11th Jul 2017
Part works and installed as advertised. light soldering for two connectors required, but was fairly easy. Love my phone again.
Posted by Tyson Collins on 10th Jul 2017
Replaced charging port PCB in about 10 minutes. Only two solder joints were required. Otherwise, the swap was relatively straightforward. Phone charges perfectly fine now. Highly recommend for repair.
Showing reviews 1-10 of 13 | Next